Vivitar DVR-620 User Manual download pdf (Page 6)

When powering the camera ON for the first time the camera will take you through the initial

camera setup.

Powering the Camera ON

1) Batteries

Make sure the batteries have been inserted properly into your digital camera, according to

the polarity shown inside the battery compartment.

Use 2 x AA (1.5v) batteries. Alkaline batteries are recommended. (Batteries not included.)

Note:

 Remove the batteries from the camera when not in use for an extended period.

 Do not mix alkaline and non-alkaline batteries.

 Some camera features (Flash) will not work if the battery power level is low.

 The energy status of the power is displayed on LCD as shown below:

Full battery power Medium battery power Low battery power

2) SD Card

Make sure an SD card has been properly inserted into your camera. (SD card not included.)

To properly insert the SD Card:

Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD

card slot). Push the SD card until you hear a slight clicking sound. This indicates the SD

card has been inserted correctly.

Note:

 After the camera is powered on, an SD icon will appear on the LCD display. If you do

not see the SD icon on the display, please check if the card was inserted properly.

 Make sure the SD card is not locked (check the lock switch on the side of the SD card). If

the SD card is locked this will prevent the camera from saving captured photos to the SD card.

3) Power On

Press the POWER button to turn on the camera.

1 2 3 4 5 6 7 8 9 10 11 ... 59 60

No comments

Vivitar DVR-620 User Manual Page 6